This system at every stage garanties a efficient and controlled product.

The Hot press CHTP/2T is equipped with an automatic continuous-cycle system for eyewear frame colouring (hot Transfer method) after painting.
It uses the heat applied on the frames by two thermostat-controlled lower "heads" and simultaneous compression of an upper head (covered with silicon rubber),
designed to ensure suitable and uniform pressure of the alluminium film (Transfer) on the frame below during the hot transfer process.

The Hot press CHTP2T as a specific system to set separately the temperature of the "heads" and the time by electronic instruments.
The lower heads have been studied with particular attention in order to allow and guarantee the most complete adaptability to frames of different sizes and shapes.

• Case in Stainless stell Aisi 304∫10/10.
• Max working temperature: +250°C
• Temperature range: from room temperature to +300°C
• Security system: auto checking thermoregulator for electric turning off of the heating.
• Supply: 220 Volt - 50/60 Hz monophase.
• Supply air compressed: 8 bar (max 12 bar) on consumption of about 250 lt/min.
• Power: 800 W.
• Dimensions: mm 620x400x590h.
• Weight: 46 Kg.
• Extractor fan.

Safety standards in specification CE.
One year unconditional guarantee against breakage and flaws in materials.

TECHNICAL DATA

Heating elements: 2.000 W
Current: 220 V – 50/60 Hz
Temperature: 220°C max
Plate Size: 380x500 mm
Weight: 40 Kg
Accessories on request: plate 150x150 mm